Running a LAN line to a rooftop CCTV camera, a Wi-Fi access point on the boundary wall, or a second building across the yard? You need an outdoor network cable, not the grey indoor roll left over from the office. The short answer for most homes, shops and small offices in Bangladesh: use solid copper Cat6 with a UV-resistant PE jacket, keep each run under 90 m, put it in conduit where rats can reach it, and add surge protection where the cable enters the building. Below is why, and when shielded cable, direct-burial cable or fibre is the better choice.
What Is an Outdoor Network Cable?
It is a twisted-pair Ethernet cable built to survive sun, rain and heat. The copper pairs are the same as indoors. The difference is the jacket and, on some types, the filling and support wire.
- Indoor cable usually has a PVC jacket. PVC is flexible, but it turns brittle and cracks after long exposure to sunlight.
- Outdoor cable uses a black polyethylene (PE or LLDPE) jacket that resists UV and moisture. Some models have an inner PVC sheath under the outer PE sheath.
Outdoor PE cable is usually not fire-rated for use inside buildings, so installers bring it indoors only a short way and change to indoor cable at a junction box or patch panel.
Cat5e vs Cat6 vs Cat6A for Outdoor Runs
| Point | Cat5e | Cat6 | Cat6A |
|---|---|---|---|
| Rated bandwidth | 100 MHz | 250 MHz | 500 MHz |
| 1 Gbps (1000BASE-T) | Up to 100 m | Up to 100 m | Up to 100 m |
| 10 Gbps (10GBASE-T) | Not specified | About 37 to 55 m, depends on alien crosstalk | Up to 100 m |
| Best outdoor use | Short runs to one camera | CCTV, access points, building links | Future 10G backbone runs |
For CCTV and Wi-Fi, Cat6 is the sensible default. Cameras and most access points use well under 1 Gbps, and Cat6 gives margin for heat and age. Pay for Cat6A only when you need 10 Gbps between buildings and fibre is not an option.
UTP vs Shielded (FTP, STP) Outdoors
UTP relies on the twists in each pair to reject noise. FTP adds a foil around the pairs, and S/FTP adds a braid as well. Shielding helps beside generator lines, motors, lift rooms and heavy power cables, which are common on Dhaka rooftops.
The catch: a shield only works when it is bonded to earth through shielded connectors and a grounded rack or surge protector. If you cannot ground it properly, a good UTP cable routed away from power lines is often the better choice.
Direct Burial, Gel-Filled and Aerial Cable
Conduit-grade outdoor cable
Standard outdoor Cat6 with a PE jacket is made for walls, rooftops and conduit. It is not designed to lie bare in wet soil.
Direct-burial and gel-filled cable
Direct-burial cables add water-blocking. Some fill the gaps around the pairs with gel (flooded cable), so water cannot travel along the inside if the jacket is cut. Outside-plant ranges such as Superior Essex BBDG6 add corrugated steel armour for burial or open trench, and the maker says its unarmoured version should go in a duct or conduit. Wipe the gel off before fitting connectors.
Aerial cable with messenger wire
For a span between two buildings or poles, use a figure-8 aerial cable. A galvanised steel messenger wire runs inside the same jacket and carries the weight. Tie the messenger, not the cable, to the hooks. A normal cable hung in the air stretches its copper pairs under its own weight and the wind.
Solid Copper vs CCA: The Most Important Check
CCA (copper clad aluminium) is aluminium wire with a thin copper coating. A lot of cheap "Cat6" sold loose in markets is CCA. Avoid it, especially outdoors and with PoE.
- Not standard: TIA-568 category cabling calls for copper conductors, so CCA cannot be a true Cat5e or Cat6 cable, whatever the jacket says.
- Higher resistance: Fluke Networks says aluminium has about 55% more resistance than copper of the same diameter. That means more heat and voltage drop, so PoE cameras at the far end can reboot or fail to start.
- Fragile: aluminium is more likely to break when flexed and can corrode at the terminations.
How to spot it:
- Read the jacket print. Look for "CCA", "copper clad" or a missing conductor description.
- Scrape a cut conductor with a blade. Silver under the copper means aluminium.
- Compare weight. A copper 305 m box is clearly heavier, although some sellers add weight to the packaging.
- Be wary of a price far below known brands.
Fluke Networks explains the risks in its article on why CCA cable is not worth the savings.
The 100 m Limit and PoE Over Outdoor Runs
TIA-568 limits an Ethernet channel to 100 m: up to 90 m of fixed cable (the permanent link) plus up to 10 m of patch cords. Plan each outdoor run for 90 m or less.
| PoE standard | Power at the switch port | Power at the device | Typical device |
|---|---|---|---|
| IEEE 802.3af (PoE) | 15.4 W | 12.95 W | Fixed IP camera, basic access point |
| IEEE 802.3at (PoE+) | 30 W | 25.5 W | Camera with strong IR, dual-band AP |
| IEEE 802.3bt Type 3 | 60 W | 51 W | PTZ camera, high-end AP |
| IEEE 802.3bt Type 4 | 90 W | About 71 W | Large PTZ, small displays |
The difference between the two power columns is lost in the cable, which is why solid copper matters on long, hot rooftop runs.
Some CCTV switches have a long-range mode. D-Link's datasheet for the D-Link DGS-F1010P-E PoE switch says ports 1 to 8 can deliver power up to 250 m in Extend mode, at 10 Mbps. That suits one camera stream, not a Wi-Fi access point. Our CCTV camera setup cost guide covers the rest of a camera system.
Many ISP routers and ONUs run from a 12 V adapter, and some outdoor radios use 24 V passive PoE, which is not IEEE PoE. Check the label before connecting. To keep the router and ONU online during load shedding, use a mini UPS for router and ONU.
Weatherproofing, Conduit and Lightning Protection
Connectors and boxes
- Never leave a bare RJ45 joint outside. Use an outdoor junction box, or the waterproof cap that comes with most outdoor cameras.
- Leave a drip loop below each box and camera so rain runs off instead of into the connector.
- Keep pairs twisted to within about 13 mm of the contacts, and check every end with a network cable tester before closing the box.
Conduit and routing
Rats chew cable in roof spaces and drains, and roofs here get very hot in summer. Run outdoor cable in PVC or GI conduit, clamp it regularly, and keep it off the hot roof surface where you can. Seal the wall entry hole against water and rodents.
Do not share a conduit with mains power, do not bend the cable tighter than about four times its diameter, and do not pull it hard enough to stretch it. That damage reduces Cat6 performance even when the jacket looks fine.
Grounding and surge protection
A long outdoor copper run can pick up surges from nearby lightning during the monsoon. Fit an Ethernet surge protector where the cable enters the building, and another near an exposed pole-mounted camera or access point. Bond each one to a real earth point with a short, straight wire; without an earth it gives little protection.
When Fibre Is Better Than Copper
- The run is longer than 90 m, such as across a factory compound.
- The two buildings have separate electrical supplies or earths. Fibre carries no electricity, so it cannot pass a surge or earth fault between them.
- The route passes heavy electrical equipment or high-voltage lines.
The trade-off: fibre needs media converters or SFP ports at both ends, cannot carry PoE, and needs a splicer or ready-made patch cords. Your ISP drop is usually fibre already, ending at the ONU.
How to Calculate the Cable Length
- Walk the real route with a tape: along the wall, up, across the roof and down. Do not measure in a straight line.
- Add every vertical drop and rise, including up to the camera bracket.
- Add 1 to 2 m of slack at each end for termination.
- Add about 10% for bends and waste.
- Check that each run stays under 90 m. If not, move the switch closer or plan fibre.
Example: 25 m along the roof edge, a 6 m drop to the switch, a 3 m rise to the bracket and 3 m of slack make 37 m. With 10% added, about 41 m. Eight similar cameras need around 330 m, a little more than one 305 m box.
Outdoor Network Cable Buying Checklist
- Cat6 printed on the jacket for most jobs, Cat6A for 10G.
- Solid bare copper conductors, no "CCA" marking.
- Black UV-resistant PE or LLDPE outer jacket.
- Direct-burial rating for underground, or a messenger wire for aerial spans.
- Shielded only if you will ground it properly.
- Matching RJ45 plugs, outdoor boxes, conduit and a tester.
In our range, the D-Link NCB-C6UBLKR-305-O Cat6 outdoor network cable is a 305 m reel of solid copper Cat6 UTP with a black UV-resistant PE jacket, for rooftop, wall and building-to-building runs. It is conduit-grade, not a direct-burial or messenger cable. For indoor sections, see our UTP cable collection.
Outdoor Network Cable Price in Thakurgaon
Searching for an outdoor network cable price in Thakurgaon? Our product page prices are the same everywhere in Bangladesh. We deliver Cat6 cable rolls, PoE switches, cable testers and mini UPS units across Thakurgaon district, including Thakurgaon Sadar, Pirganj, Ranisankail, Baliadangi and Haripur, with cash on delivery. One outdoor reel can link a shop's rooftop cameras or a home's second building. Need help choosing? Call or WhatsApp us and talk in Bangla.
Frequently Asked Questions
Can I use indoor Cat6 cable outdoors in Bangladesh?
Only for a short time, or fully inside sealed conduit out of the sun. An indoor PVC jacket turns brittle in strong sunlight, and cracks let monsoon water reach the pairs. For any exposed run on a wall, roof or pole, an outdoor cable with a UV-resistant PE jacket lasts much longer.
How far can an outdoor network cable run with PoE?
Ethernet and IEEE PoE are specified for a 100 m channel, about 90 m of fixed cable plus patch cords. Some CCTV switches offer an extend mode that reaches up to 250 m at 10 Mbps. For longer runs at full speed, use fibre or place a switch closer to the cameras.
Is shielded cable better for outdoor CCTV?
Not always. Shielded FTP cable helps beside generators, motors and heavy power lines, but only when the shield is grounded through shielded connectors and an earthed switch or surge protector. A solid copper UTP cable routed away from power lines works well for most home and shop camera setups.
Can I bury an outdoor Cat6 cable directly in the ground?
Only if the maker rates it for direct burial, which usually means gel or water-block filling and often armour. Bury a standard outdoor PE-jacketed cable inside a PVC or HDPE pipe. The pipe also protects it from digging, rats and standing water, and lets you pull a new cable later.
Buy from Megabuy BD
Megabuy BD sells authentic Cat6 network cables, PoE switches, routers, cable testers and mini UPS units for home, shop and office networks. We deliver nationwide with cash on delivery, and Dhaka orders usually arrive within 24 to 48 hours.
There are no comments for this Article.